Kerr Pump Corporation KT-3350XP, Руководство по эксплуатации и ремонту

Страница: 13 / 34

TECHNICAL DATA SHEET T.D.S. NO. 4.2
PCN: ______ Supercedes PCN: _____ Date 03 ‐ 10 ‐ 06
SHORT TERM STORAGE PREPARATION PROCEDURE
1.0 SCOPE
This procedure applies to Kerr Pumps ONLY. Storage procedures for any other unit components or accessories (gear reducers, engines, etc.) are to be prepared to the specific
manufacture’s recommendations.
1.1 Short ‐ term storage is defined as storage and/or transient time less than six (6) months in an environment defined in Paragraph 2. If storage exceeding six months is
expected, the Long Term Pump Storage Preparation Procedure should be followed.
1.2 Kerr Pumps will only prepared for short term storage if so specified in the purchaser or customer order control document.
2.0 STORAGE ENVIRONMENT
A minimal environmental condition, to be met by the customer or purchaser, is a closed shelter to eliminate effects of sun, wind, sand or other debris. Large temperature and
humidity changes should be avoided to prevent coating deterioration or contamination by moisture.
3.0 PRESERVATIVE PRODUCT
3.1 The specified rust preservative will protect the internal power end parts from corrosion due to atmospheric moisture, and may be left in the pump when filled with
appropriate lubricant and placed into service. The elevated temperature of service will cause rapid depletion of the preventative protection.
3.2
The following rust preventative products or their equivalents are recommended for use in Kerr Pumps and usually available in 5 gallon, 55 gallon
containers:
CITGO: RUST ‐ O ‐ LINE OIL 10
SHELL: ENSIS OIL N
4.0 PROCEDURE
4.1 Preparation from; factory testing, inventory, or a distributor rebuild facility.
‐ Drain any oil that may be in the power end, and then fill the complete power end cavity with the specified rust preventative. After 15 to 20 minutes, drain the rust
preventative back into its storage drum for future use.
‐ Remove and clean oil level gages, pressure gages and breather caps. Replace with pipe plugs in threaded openings. All breathers shall be replaced with airtight seals,
plugs or gasketed plates. No venting is recommended as it may allow moist air in.