Kernau KDI 4853, Инструкция по эксплуатации

Страница: 41 / 90

EN
41
Water connection
Be sure that the indoor plumbing is suitable for installing a dishwasher. Also, we re-
commend that you fit a filter at the entrance of your place or apartment so as to avoid
any damage to your machine because of any contamination (sand, clay, rust etc.) that
might be occasionally carried in through the mains water supply or the indoor plum-
bing, and to forestall such complaints as yellowing and formation of deposits after
washing.
Water inlet hose
Do not use the water inlet hose of your old machine. Use the new
water inlet hose supplied with your machine instead. If you are going
to connect a new or long - unused water inlet hose to your machine
,run water through it for a while before making the connection. Con-
nect the water inlet hose directly to the water inlet tap.
Pressure supplied by the tap should be at least 0,03 MPa, but not hi-
gher than 1 MPa. If the pressure exceeds the maximum limit, install
a pressure regulator.
After the connections are made, the tap should be turned on fully
and checked for water leakages. or the safety of your machine, make
sure to always turn off the water inlet tap after each wash program-
me is finished.
NOTE: Aquastop water hose is used in some models. In case of
using Aquastop, a dangerous tension exists. Do not cut Aquastop
water spout. Do not let it get folded or twisted.
Water outlet hose
The water drain hose can be connected either directly to
the water drain hole or to the sink outlet . Using a special
bent pipe (if available), the water can be drained directly
into the sink via hooking the bent pipe over the edge of
the sink. This connection should be at a minimum of 50
cm and at a maximum of 110 cm from the floor plane.
Warning: When a drain hose longer than 4 m is used, the dishes might remain dir-
ty. In that case, our company will not accept responsibility.