Kerbl 345000, Инструкция по эксплуатации

Страница: 41 / 48

41
9.7 Setting the time
To set the current time, navigate to “Time” in the Settings
menu. When you press <- you will see the following display:
• The hour value in the time display flashes.
Set the hour to the correct time using the ^ and v keys.
Press <- to confirm.
• The minute value in the time display flashes.
Set the minute to the correct time using the ^ and v keys.
Press <- to confirm.
9.8 Selecting the language
You can select the “Lang.” item in the Settings menu. Here
you will see a display of all the possible language settings. Select your language using the ^ and v keys and press <-
to confirm your selection. The screen returns to the Settings menu. The display will now be in your chosen language.
9.9 Restoring the factory settings
You can restore the light control to its as-delivered state at any time, to reset all settings to their original values. To do so,
open the Settings menu, then Setup. Here, move the cursor to “Factory stgs”. Press <- to confirm your selection.
Next, the light control restarts.
10. Advanced settings
10.1 Adapting the sensor reading
The light sensor's reading can be adapted to suit its
installation location by adjusting the settings as appropriate.
If the light sensor is installed in a location with a
comparatively high light incidence, you can reduce the
sensor's sensitivity. To do so, select “Sensor stgs” in the main
menu. You will see the following display:
Press <- to select any circuit for setting the sensitivity. Use ^
and v to set the sensitivity of the sensor. The sensitivity value
is displayed in brackets after the current reading. It can be
set in the range between 0.8 and 7.0. The higher the
sensitivity, the more sensitively the sensor reacts and the
higher the displayed reading.
The threshold for switching the lights in TWILI mode is a reading of 50. For this control mode, set the sensitivity so that
a reading of 50 is displayed as the outdoor brightness that you wish to have as the switching value.
For AUTO mode, also base your settings on your desired brightness. Adjust the sensitivity so that the sensor reading
matches the set brightness (section 9.4) of the circuit in question (if the room has the necessary brightness).
c
1
2
3
12.15
150
Time: 00 : 00
c
1
2
3
12.15
150
-> C I R C T 1: 49 (2.0)
C I R C T 2: 49 (2.0)
C I R C T 3: 49 (2.0)
C I R C T 4: 49 (2.0)
Back