KEP INT-69R, Инструкция по установке и эксплуатации

Страница: 2 / 26

Proprietary Notice
The information contained in this publication is derived in part from proprietary and patent data.
This information has been prepared for the expressed purpose of assisting operating and
maintenance personnel in the efficient use of the instrument described herein. Publication of
this information does not convey any rights to use or reproduce it or to use for any purpose other
than in connection with the installation, operation and maintenance of the equipment described
herein.
Copyright 1990
Printed in USA. All Rights Reserved.
WARNING!
This instrument contains electronic components that are susceptible to damage by static
electricity. Proper handling* procedures must be observed during the removal, installation, or
handling of internal circuit boards or devices.
*Handling Procedure
1. Power to unit must be removed.
2. Personnel must be grounded, via wrist strap or other safe, suitable means, before any
printed circuit board or other internal device is installed, removed or adjusted.
3. Printed circuit boards must be transported in a conductive bag or other conductive container.
Boards must not be removed from protective enclosure until the immediate time of installation.
Removed boards must be placed immediately in protective container for transport, storage, or
return to factory.
Comments
This instrument is not unique in its content of ESD (electrostatic discharge) sensitive
components. Most modern electronic designs contain components that utilize metal oxide
technology (NMOS, CMOS, etc.). Experience has proven that even small amounts of static
electricity can damage or destroy these devices. Damaged components, even though they
appear to function properly, may exhibit early failure.
!