KEP INT-69R, Инструкция по установке и эксплуатации

Страница: 12 / 26

8
lc pg
- LOCK PROGRAM; When this is selected the lockout will lock only the program. The Reset can be
activated and the presets can be viewed and changed.
code
- CODE; This is a 5-digit code which will be used to lock and unlock the front panel.
setup
- SETUP; This section of the program menu sets up the operating variables.
rdec
- RATE DECIMAL LOCATION; This allows the user to program a decimal point for the rate display.
set lo
- SET LOW; This is the rate value for the lowest input (0 or 1 Volts; 4 mA). (i.e. 4 mA = 10 lbs/hr.)
SET Hi
- SET HIGH; This is the rate value for the highest input (5 or 10 Volts; 20 mA). (i.e. 20 mA = 500 lbs/
hr.)
lo cut
- LOW CUT-OFF; This is the lowest rate value to be recognized. All rate readings below this value will
assume the "set lo" value.
nor
- NORMALIZING FACTOR; This is an averaging factor (00.0 to 99.9). Higher settings provide more
normalizing (averaging) for a more stable display. Derived from the equation:
(OLD DATA x "NOR" + NEW DATA)
("NOR" + 1)
SECS
- SECONDS; This tells the unit that the High and Low input values are entered in units per second.
NNiNs
- MINUTES; This tells the unit that the High and Low input values are entered in units per minute.
hours
- HOURS; This tells the unit that the High and Low input values are entered in units per hours.
tdec
- TOTALIZER DECIMAL LOCATION; This allows the user to enter a decimal for the totalizer display.
This decimal is not a dummy decimal and will scale the totalizer display accordingly. (i.e. if the tdec is set
in the tenths position (#####.#), 100 will be displayed as 100.0)
tfact
- TOTALIZER FACTOR; This factor divides the totalizer display by 1, 10, 100 or 1000.
opt
- OPTIONS; This section of the program menu is for setting up optional features (analog out, RS232/422
serial communications).
out lo
- OUT LOW; The displayed rate value at which the unit will output 4 mA (2 lbs./hr = 4 mA out).
out hi
- OUT HIGH; The displayed rate value at which the unit will output 20 mA (2000 lbs./hr = 20 mA out).
BAuD
- BAUD RATE; The baud rate at which the RS232 or RS422 communications will operate.
9600
- 9600 BAUD; This sets the communications at 9600 Baud.
2400
- 2400 BAUD; This sets the communications at 2400 Baud.
1200
- 1200 BAUD; This sets the communications at 1200 Baud.
300
- 300 BAUD; This sets the communications at 300 Baud.