TKR-850
2
GENERAL / SYSTEM SET-UP
INTRODUCTION
SCOPE OF THIS MANUAL
This manual is intended for use by experienced techni-
cians familiar with similar types of commercial grade commu-
nications equipment. It contains all required service informa-
tion for the equipment and is current as of this publication
date. Changes which may occur after publication are covered
by either Service Bulletins or Manual Revisions, which are
issued as required.
ORDERING REPLACEMENT PARTS
When ordering replacement parts or equipment informa-
tion, the full part identification number should be included.
This applies to all parts : components, kits, and chassis. If the
part number is not known, include the chassis or kit number
of which it is a part and a sufficient description of the required
component, for proper identification.
PERSONAL SAFETY
The following precautions are recommended for personal
safety :
• DO NOT transmit until all RF connectors are secure and
any open connectors are properly terminated.
• SHUT OFF this equipment when near electrical blasting
caps or while in an explosive atmosphere.
• This equipment should be serviced by only qualified tech-
nicians.
SERVICE
This radio is designed for easy servicing. Refer to the
schematic diagrams, printed circuit board views, and align-
ment procedures contained in this manual.
Merchandise
received
Choose the type
of transceiver
Installation in the
optional space
Frequency range (MHz)
TX/RX 440~470
TX/RX 450~480
TX/RX 480~512
TX/RX 400~430
RF power
40W
40W
40W
40W
Type
E
K
K2
K3
See page 4.
A personal computer (IBM PC or compatible), programming interface (KPG-46),
and programming software (KPG-91D) are required for programming.
See page 40.
The RX RF BPF (L2,L4,L5 on TX-RX unit A/2) must be aligned to obtain
the maximum sensitivity at a programmed frequency.
YES
NO
DC power
supply or
duplexer?
KES-4 or KES-5
installation
YES
NO
External speaker?
Repeater
programming & setup
Delivery
SYSTEM SET-UP