TK-3202
5
Assembling the Battery Release Lever
1. Place the lever (
➋
) onto the stopper (
➊
).
2. Place the thick spring (
➌
) onto the lever.
3. Hook the right and left ends of the thin spring (
➍
) onto the
tabs of the stopper, then place the thin spring onto the
lever (
➎
).
4. Slide the shaft through the hole of the stopper and lever
(
➏
).
DISASSEMBLY FOR REPAIR
Cautions for Assembly
■
Attaching the positive terminal to the chassis
Always attach the positive terminal to the chassis, using
the following procedures, before mounting the TX-RX unit
onto the chassis.
1. Remove the holder assembly (
➋
) from the packing (
➊
) of
the positive terminal.
2. Mount the packing of the positive terminal into the chassis
hole (
➌
).
3. Mount the holder assembly into the packing of the posi-
tive terminal (
➍
).
➊
➋
➌
➍
➎
➏
➋
➊
➌
➍
■
Mounting the chassis to the case assembly
1. Confirm that the waterproof packing attached to the cir-
cumference of the chassis is securely inserted in the
groove of the chassis (
➊
).
2. Twist the speaker wires twice, then attach the speaker to
the speaker recess of the case assembly (
➋
). Make sure
the speaker is securely inserted.
3. Insert the upper part of the chassis into the case assembly
(
➌
).
Caution:
Take care that the speaker lead wire is not
caught by the microphone element.
4. Press the chassis (
➍
) and the case assembly together to
attach them.
Caution:
If the packing of the SP/MIC does not come to
the correct position after attaching the chassis to the case
assembly, reposition the packing with your fingers.
➊
➋
Confirm that the
waterproof packing is
securely inserted in the
groove of the chassis.
➌
➍
➍
