Kenwood KRF-X9992D, Руководство по подключению и настройке

Страница: 117 / 145

Using P
o
w
erT
ouch
58 Audio-Video Receiver KRF-X9992D
For more information on recording with any connected device,
see the device’s instruction manual.
Here are some helpful hints for recording:
• If you’re recording from a digital source, select the source
device, then set the listen mode to Stereo (Touch ).
Home VCRs can only place 2 channels of sound on a tape,
and this enables the receiver to “downmix” from Dolby
Digital or MPEG multi-channel sound down to 2 channels.
For more information on setting listen modes, see “To set the
listen mode manually” on page 20.
• If you’re recording from a digital source, any action other
than adjusting the volume may cause the sound to “clip” on
the recording.
• You cannot record from the component you are using to
record. For example, if you’re recording on a VCR connected
to the VIDEO1 jacks, select a source other than Video 1.
• If your source is a camcorder or other video unit, refer to the
instruction manual for the particular unit you’re recording
from.
Digital to Digital Recording:
The PCM digital signal input through any DIGITAL IN jack is
output digitally at the optical jack. Be sure you have connected a
cable from the OPTICAL (DIGITAL OUT) jack on the receiver to
the MD recorder’s digital input. For more information on this
connection, see “Connecting Your MD Recorder or Primary Tape
Deck” on page␣ 20 of the
Connections and Setup Guide .
Dolby Digital and MPEG signals cannot be recorded.
How Do I Record (Edit Mode)?