Kenwood KRF-X9992D, Руководство по подключению и настройке

Страница: 139 / 145

80 Audio-Video Receiver KRF-X9992D
T
roubleshooting
Receiver/Tuner
• The volume setting (-66dB is selected by default)—see
“Adjusting the Volume” on page␣ 10 of this manual
• The tuner’s receiving band (FM is selected by default)—
see “Tuner” on page␣ 50 of this manual
• The tuner’s frequency (87.5MHz is selected by default)—
see “Tuner” on page␣ 50 of this manual
• The tuner’s preset memory—you will need to reset your
stored radio stations (see Chapter Two of the Connections
and Setup Guide)
• The surround setting—see “What are Listen Modes?” on
page␣ 16 of this manual .
• The speaker settings—you will need to reset your speaker
settings ( see Chapter Two of the Connections and Setup
Guide )
4. Reset the cleared settings before operating the receiver again.
The sound is distorted, and the CLIP indicator on the
receiver’s front panel flashes red continually, or stays red
for more than 1 second at a time
Lower the analog input level for the source device you’re lis-
tening to. (Setting the proper input level eliminates distortion
that occurs if a source device’s output level is too high. When
this happens, the front panel CLIP indicator will flash red
continually or remain red for periods of 1 second or longer.
Occasional brief flashing of the CLIP indicator is okay).
1. Select the icon for the source device. For CD1, Video2,
Video3, and Video 4, also select the Input Analog icon.