Kentrox DataSMART T3/E3 IDSU, Руководство по установке

Страница: 20 / 52

20 Chapter 3: Initial installation and power up
Install the chassis
You can install the DataSMART T3/E3 IDSU as a stand-alone unit on a desktop or you
can mount it in a standard equipment rack.
Clearance
requirements The clearance requirements for the IDSU enclosure are shown below. Clearance of at least
1 in. (25 mm) is required on either side of the unit for cooling, and clearance of 4 in.
(102 mm) is required at the rear of the unit for cable installation. The chassis has a fan
exhaust vent in its left-side panel and an air intake vent in its right-side panel.
CAUTION!
Damage to the DataSMART T3/E3 IDSU and its components may occur if
appropriate clearances around the enclosure are not provided for cooling.
Figure 5—DataSMART T3/E3 IDSU clearance requirements
Mounting the IDSU
on a desktop
The DataSMART T3/E3 IDSU can stand alone on a flat surface, as long as you adhere to
the clearance requirements specified above. Rubber feet are provided but are not required
for clearance.
1 in. (25 mm) clearance
either side
4 in. (102 mm)
clearance at rear