MAIN MOTOR
SERVICE MANUAL
ENGLISH
Edge 28B
1463165000(1)2007-02
29
MAIN MOTOR CARBON BRUSH CHECK AND REPLACEMENT
Check and replacement
Remove the hood (see the procedure in the relevant paragraph).
Remove the protections (A), (B), (C) and (D) (bayonet joint) of the main motor (E).
Disconnect the connections (F).
Remove four carbon brushes (G) by disengaging the tabs (H).
If necessary, to remove the carbon brush in the position (C), disconnect the connections (F) and remove the screws (I),
then turn the main motor (E) as necessary.
Check the carbon brushes for wear. Replace the carbon brushes when: the contact with the motor armature is insufficient,
the carbon brushes are worn, the carbon brush contact surface is not integral, the thrust spring is broken, etc.
If necessary, replace the carbon brushes. Replace the carbon brushes as an assembly.
Reset
Assemble the components in the reverse order of disassembly.
I
I
G
F
H
G
H
F
C
A
B
F
E
D
S301606
1.
2.
3.
4.
5.
6.
