Kensol-Franklin VALUE LINE, Инструкция по эксплуатации

Страница: 15 / 47

Page
6. Stop the press immediately when a malfunction is reported and correct before resuming operation.
7. Establish, publish and enforce a firm policy of safety regulations.
8. Take immediate action to prevent a recurrence of all "close calls" before they become accidents.
9. Never change wiring.
10. Never change air piping.
11. Never substitute component parts.
12. Dies and stripping material should be checked and maintained for proper cutting and stock ejection.
13. Never run a press that has been modified.
14. Only use the press for its intended use.
Press Operator's Safety Tips
1. Operator should never operate with any press or safety device malfunction.
2. Perform daily inspections as required by ANSI B65.5-1996 Section 16.3.1 (Refer to Safety Test Trip, and see figure 3.4)
3. Make a pre-operation check of all operating controls, safeguarding devices, bottom and side sheet or material guides, alert
signals, die and material being worked.
4. Never attempt to correct or remove misfed sheets before stopping the platen in the fully open position. Report die trouble
to supervisor.
5. Never operate, service or adjust the press, or install dies without proper understanding of the instructions in the Instruction
Manual.
6. Never sit on, stand on or bend over the platen with the flywheel turning.
7. Never makeready or set stock guides before stopping the motion of the flywheel.
8. Obey alert or warning signals on the press.
9. Stop the machine if it malfunctions. Report any questionable operation, unusual action, unsafe condition or improper
maintenance to the proper person.
10. When changing setting of press controls for a different mode of operation, test the machine cycle to be sure it operates as
expected.
11. Check the work area to be sure it is free of objects that could cause one to slip or trip.
12. Wear proper personal protective equipment specified by the employer.
13. Shut off power to the press when it is not in use.
14. Never talk to another person while feeding the press.
15. Never reach over, under or around press safety devices or try to bend, check, modify or remove, point of operation safety
devices.
Instruction Manual - 19" x 25"