Kensol-Franklin VALUE LINE, Инструкция по эксплуатации

Страница: 10 / 47

Page
SECTION III
OPERATION
PRESS CYCLE - START /STOP
-Turn power on
-Put main motor into operation (always starting the motor at low speed) and select
desired speed
-Press should be in the "DIECUT" or "FOIL" mode
-Select desired cycle:
• "STOP OPEN" allows one press cycle only with the press stopping in the open position (generally used for
setting up)
• "STOP CLOSED" allows one press cycle only with the press stopping in the closed position (for
transferring counters)
• "DWELL OPEN" activates "dwell open" timer, allowing the press to stop in the opened position for the
amount of time set on timer
• Dwell closed activates dwell-closed timer, which allows the press to stop in the closed position for the
amount of time set on the timer
• Continuous allows press to run continuously
-Pull "STOP/SAFE READY" button out, placing it in the "ready position"
-Auxiliary safety must be placed forward in the "run" position
-Press cycle "START"
-To stop the machine, depress "STOP/SAFE - READY" button
IMPRESSION ADJUSTMENTS - DUAL MICROMETER DESIGN
The impression is adjusted using the dual micrometers. Each side of the bridge is adjusted separately. This allows for
faster and more accurate makeready, reducing down time to a minimum.
First loosen the impression sleeve locking bolts using the supplied wrench. With the other end of the wrench, turn the
impression sleeve to the desired setting and then re-tighten the lock bolts.
WARNING: Never advance one side of the bridge ahead of the other more than 0.015", or 1/64".
DO NOT PACK UNDER THE CUTTING PLATE IN PREFERENCE TO ADVANCING IMPRESSION BY
MICROMETER ADJUSTMENTS.
CAUTION
NEVER TAKE AN IMPRESSION WITHOUT FIRST TIGHTENING THE LOCKING BOLTS ON IMPRESSION
SLEEVE.
ALWAYS RETURN IMPRESSION ADJUSTMENT TO "0" WHEN STARTING A NEW JOB
MOUNTING DIES IN PRESS
Die Mounting
CAUTION: Before mounting die on press, refer to the safety standard for stand-alone presses, ANSI #B65.5-1996, section
18.2, Inch-safe-service method.
For your safety and for ease of operation, chaseless die mounting fasteners have been supplied with your press. Refer to
the makeready manual for proper die setup procedures.
Instruction Manual - 19" x 25"