Kensol-Franklin VALUE LINE, Инструкция по эксплуатации

Страница: 8 / 47

Page
The machine is equipped with a master control console and panel box completely wired at the factory.
Only qualified personnel should install and service electrical equipment.
WARNING: Only connect incoming electrical power as indicated on the enclosed wiring diagram.
A separate, fused, wall disconnect switch should be installed for each machine.
LUBRICATION
WARNING: Turn off main electrical power and stop the flywheel before applying any lubrication.
Value Line presses have bearings that work under relatively slow speeds and extreme pressures. Proper lubrication
affects the life of a press and is one of the most important items affecting its proper operation. Better results will be obtained by
applying a small quantity of lubricant frequently rather than a large amount at long intervals.
We recommend SAE 30 oil in the lubrication system.
Starting Up a New Machine
Fill the oil reservoir. To fill lines and lubricate bearings before starting new machine, pull instant feed knob on Bijur
Lubricator and release to allow pump to discharge. Repeat until oil is in evidence at all bearings.
Gears - New Machine
IMPORTANT: Before starting up a new machine, make sure all gear teeth are well lubricated. Lubricate manually if
necessary. Never operate the machine with the gears dry.
Make sure that oil holes are free of dirt, paint, or any other foreign matter.
All areas of the machine that require oil lubrication are taken care of automatically by the Bijur lubricating system
consisting of a pump unit which forces oil through a branched tubing line to Meter-Units, one of these being located at or near
each bearing. The pump measures the total quantity of oil fed to the system and the Meter-Units proportion this quantity
according to the individual requirements of the bearings.
Oil
Use only a clean oil of SAE 30 viscosity. NEVER use oil containing graphite, soap, or other foreign substances. Refill
reservoir before oil level drops to the bottom of oil level gauge.
Meter Units
Meter-Units are self-contained, non-adjustable units. Letters stamped on them indicate the type and the flow rate; the
higher the number, the greater the flow. The Meter-Units offer such high resistance to oil flow that they are the controlling factors
in oil distribution. As a result, there is practically no variation in oil delivery, normally caused by flow resistance in the tubing,
variation in bearing wear or initial fit. Check valves in the Meter-Units prevent reverse flow and keep the tubing full of oil at all
times. A Meter-Unit may be mounted directly at a bearing, at an adjacent junction or at a tee head.
Use FJB Meter-Units with this pump.
Instruction Manual - 19" x 25"