Kensol-Franklin VALUE LINE, Инструкция по эксплуатации

Страница: 7 / 47

Page
SECTION II
INSTALLATION
The complete machine comes with rust preventative on exposed surfaces to protect it from corrosion and is bolted to
heavy skids to protect it from damage.
SELECTING LOCATION
Leave the press on skids until it is moved into its permanent position. See the floor plan for the area required and
distribution of weight. A solid foundation is recommended for the machine. It should be located over the building beam supports
if possible. Proper consideration of working space around the installation area and good lighting for the operator are important
factors in selecting a location.
WARNING: Check the capacity of the lifting equipment in your plant before moving your new press.
LEVELING AND PLACEMENT OF AIR-LOC PADS
Remove the skids and place the vibration pads (if used) under the feet of the press. Thicker pads go down first, then the
thinner pads. Place a machine level on the main shaft or on the pinion shaft, and drive wedges under the frame corners until a
level position is obtained. Shims should be placed between thick and thin vibration pads. Remove the wedges and secure the
press to the floor.
CLEANING PARTS
Uncrate all parts and clean thoroughly to remove all dirt, foreign matter and protective coatings. Check all parts of the
machine to see that they are free from foreign matter that may be lodged in holes, pockets or gear teeth.
Check and clean out all oil holes to make sure they are not obstructed with dirt, grease or paint.
Instructions for Removing Parallel Bar
1. Wire main power lines from the disconnect switch to the press. (See wiring diagram)
2. Facing the right side of the press attach the supplied crank handle to the end of the flywheel shaft.
3. Turn the crank handle counterclockwise until the bridge opens.
4. Remove the parallel bar.
5. Remove the crank handle.
6. The press is now ready to run.
CAUTION :
TURN THE PRESS OVER VERY SLOWLY WITH THE FLYWHEEL RUNNING IN THE PROPER DIRECTION TO
MAKE SURE ALL FUNCTIONS ARE IN PROPER WORKING ORDER BEFORE APPLYING FULL POWER. THE
MAIN GEARS SHOULD REVOLVE AWAY FROM THE OPERATOR IN THE DIRECTION AS INDICATED BY THE
ARROW ON THE SIDE OF THE GEAR.
WIRING
Instruction Manual - 19" x 25"