Kennmex K875, Руководство по обслуживанию оборудования

Страница: 7 / 44

Error Message Corrective Action
Floppy Disk CNTRLR Error or No
CNTRLR Present
Cannot find or initialize the floppy drive
controller. Make sure the controller is
installed correctly and firmly. If there are no
floppy drives installed, be sure the Diskette
Drive selection in Setup is set to NONE.
Floppy disk(s) fail Cannot find or initialize the floppy drive
controller or the drive. Make sure the
controller is installed correctly. If no floppy
drives are installed, be sure the Diskette Drive
selection in Setup is set to NONE or AUTO.
Hard Disk Initializing Hard Disk Install
Failure
Cannot find or initialize the hard drive
controller or the drive. Make sure the
controller is installed correctly. If no hard
drives are installed, be sure the Hard Drive
selection in Setup is set to NONE.
Hard Disk(s) diagnosis fail The system may run specific disk diagnostic
routines. This message appears if one or more
hard disks return an error when the
diagnostics run.
Invalid EISA Configuration The nonvolatile memory containing EISA
configuration information was programmed
incorrectly or has become corrupt. Return
EISA configuration utility to correctly
program the memory.
Keyboard error or no keyboard present Cannot initialize the keyboard. Make sure the
keyboard is attached correctly and no keys are
being pressed during the boot. If you are
purposely configuring the system without a
keyboard, set the error halt condition in Setup
to HALT ON ALL, BUT KEYBOARD. This
will cause the BIOS to ignore the missing
keyboard and continue the boot.
7