Kennmex K875, Руководство по обслуживанию оборудования

Страница: 6 / 44

Error Message Corrective Action
Diskette Drivers or Types Mismatch
Error-Run Setup
Type of diskette drive installed in the system
is different from the CMOS definition. Run
Setup to reconfigure the drive type correctly.
Display switch is set incorrectly. The display switch on the motherboard can be
set to either monochrome or color. This
message indicates the switch is set to a
different setting than indicated in Setup.
Determine which setting is correct, and then
either turn off the system and change the
jumper; or, enter Setup and change the
VIDEO selection.
Display Type has changed Since Last Boot
Changed.
Since last powering off the system, the
display adapter has been changed. You must
configure the system for the new display type.
EISA Configuration Checksum Error The EISA nonvolatile RAM checksum is
incorrect or cannot correctly read the EISA
slot. This can indicate either the EISA
nonvolatile memory has become corrupt or
the slot has been configured incorrectly. Also
be sure the card is installed firmly in the slot.
EISA Configuration Is Not Complete The slot configuration information stored in
the EISA nonvolatile memory is incomplete.
Error Encountered Initializing Hard Drive Hard drive cannot be initialized. Be sure the
adapter is installed correctly and all cables are
correctly and firmly attached. Also be sure the
correct hard drive type is selected in Setup.
Error Initializing Hard Disk Controller Cannot initialize controller. Make sure the
cord is correctly and firmly installed in the
bus. Be sure the correct hard drive type is
selected in Setup. Also check to see if any
jumper needs to be set correctly on the hard
drive.
6