Kennmex K875, Руководство по обслуживанию оборудования

Страница: 9 / 44

Error Message Corrective Action
No boot device was found This could mean that either a boot drive was
not detected or the drive does not contain
proper system boot files. Insert a system disk
into drive A: and press Enter. If you assumed
the system would boot from the hard drive,
make sure the controller is inserted correctly
and all cables are properly attached. Also be
sure the disk is formatted as a boot device.
Then reboot the system.
Offending Address Not Found This message is used in conjunction with the
I/O CHANNEL CHECK and RAM PARITY
ERROR messages when the segment that has
caused the problem cannot be isolated.
Offending Segment: This message is used in conjunction with the
I/O CHANNEL CHECK and RAM PARITY
ERROR messages when the segment that has
caused the problem cannot be isolated.
Override enabled defaults loaded If the system cannot boot using the current
CMOS configuration, the BIOS can override
the current configuration with a set of BIOS
defaults designed for the most stable,
minimal-performance system operations.
Press a Key to Reboot This will be displayed at the bottom of the
screen when an error occurs that requires you
to reboot. Press any key to reboot the system.
Press ESC to skip memory test You can press ESC to skip the full memory
test.
Press [F1] to Disable NMI, [F2] to Reboot When BIOS detects a non-maskable interrupt
condition during boot, this will allow you to
disable the NMI and continue to boot; or you
can reboot the system with the NMI enabled.
9