8
When removing the washer from the carton base, be
sure to remove the foam drum support in the middle of
the carton base. See drawing below.
If you must lay the washer down to remove the base
packaging materials, always protect the side of the
washer and lay it carefully on its side.
DO NOT
lay the
washer on its front or back.
To prevent internal damage during transport, the washer
is equipped with four shipping bolts and plastic retainers.
IMPORTANT:
v
These shipping bolts and retainers
MUST NOT
be
removed until just before moving the washer into its
oQDOSRVLWLRQ
v
These bolts and retainers
MUST
be removed before
operating the washer.
v
Failure to remove shipping bolts and retainers may
cause severe vibration and noise, which can lead to
permanent damage to the washer.
NOTE:
The power cord is secured to the back of the
washer with a shipping bolt to help prevent operation
with shipping bolts in place.
1. Starting with the bottom two shipping bolts, use the
wrench (included) to fully loosen all four shipping
bolts by turning them counterclockwise.
2. Remove the bolt assemblies by wiggling them
slightly while pulling.
3. Locate the four hole caps included in the accessory
pack and install them in the shipping bolt holes.
NOTE:
Save the bolt assemblies for future use. To
prevent damage to internal components, DO NOT
transport the washer without reinstalling the shipping
bolts.
Shipping
Bolts
Power
Cord
Shipping
Bolts
Hole Cap
Foam Tub
Support
Carton
Base
813$&.,1*$1'5(029,1*6+,33,1*%2/76
,167$//$7,21,16758&7,216
Содержание 796. 4139 series
Страница 1: ......
Страница 2: ... jw1213DBCH BB ...
Страница 63: ...62 NOTES ...
Страница 64: ...63 NOTES ...