10
Setting Surface Controls
(cont’d)
Off
Left Rear
Left Front
Off
Lit
e
H
i
Hi
Lo
Mu
lti
Lo
Off
Lit
e
H
i
Med
Lo
Off
Hi Lo
Hi Lo
Multi
Lite
Off
Hi Lo
Hi Lo
Multi
Lite
Mult
i
Mult
i
Figure 1
Figure 2
Figure 3
Off
Lite
Hi
Hi
Lo
Mu
lti
Lo
Left Rear Burner
lite position
Left Rear
Burner
adjustment
area
Left Center Burner
lite position
Bridge Burner (left rear + left
center) adjustment area
Setting the Bridge Burner
The Bridge Burner should be used with rectangular shaped cookware. Cookware like the cast-
iron Griddle that is supplied with your cooktop is designed specifically for best results with the
Bridge Burner.
The Bridge Burner feature may be used to combine the cooking power of 2 or if needed 3 gas
surface Burners located along the left-hand side of the glass cooktop. The left rear and left center
Burners are controlled by the left rear surface Control Knob. In addition the left front Burner may
be added to the Bridge Burner with the left front gas Control Knob.
Operating only the Left Rear Burner
1.
Place cooking utensil centered over the left-rear surface Burner Grate.
2.
Push the left rear surface control knob in and turn
counterclockwise
out of the OFF
position (See Figure 2).
3.
Release the knob and rotate to the
LITE
position. Note: All electronic surface ignitors
will spark at the same time. However, only the left rear Burner will ignite.
4.
Visually check that the left-rear burner has lit. Adjust the flame size by turning the
control knob between the
first HI and LO settings
(See Figure 3).
DO NOT
cook with
the surface control knob in the LITE position (The electronic ignitor will continue to
spark if the knob is left in the LITE position).
Operating the Bridge Burner
1.
Place cooking utensil centered over the left-rear surface Burner Grate.
2.
Push the left rear surface control knob in and turn
counterclockwise
out of
the OFF position (See Figure 2).
3.
Release the knob and rotate to the
LITE
position (See Figure 2 & 3). Note:
All electronic surface ignitors will spark at the same time. However, only
the selected surface Burner will lite.
4.
Visually check that the left rear Burner has lit.
5.
Continue to rotate the gas control knob counterclockwise past the first LO
setting to the arrow marked
Multi.
The left center burner will lite.
6.
Visually check that both the left rear and left center Burners are lit. Adjust
the flame size by turning the control knob between the
second HI and LO
settings
(See Figure 3).
7.
Add the left front Burner if needed. Once lit, visually adjust the flame size
of the left front Burner to match the flame size of the Bridge Burner.
DO
NOT
cook with any of the surface control knobs in the LITE position (The
electronic ignitor will continue to spark if the knob is left in the LITE
position).
