Kenmore 146.48590710, Инструкция по использованию и уходу

Страница: 36 / 84

36 · 146.48591710
Rotisserie Kit Assembly (Rotisserie motor on left side as shown)
□
Remove warming rack from firebox. Insert motor support into motor support bracket
preassembled to left side of firebox (A).
□
Insert rotisserie motor onto motor support (B). Make sure to insert motor with power cord at
bottom.
□
Slide the shaft collar onto the rotisserie rod followed by the two forks (forks should be pointing
toward each other). Make sure that shaft collar is positioned near rounded end of rotisserie rod.
Hand tighten the collar set screw and the wing set screw on each fork (C). Do not fully tighten
screws in this step.
□
Insert the pointed end of the rotisserie rod into the hole for it in the motor. On the other end of the
rod, slide the shaft collar to the point where the groove in the collar will lay securely in the slot in
the firebox wall (D). Slide the forks to typical cooking position on the rod. Use a slotted
screwdriver to fully tighten the collar and fork set screws. Loosen and tighten fork screws as
necessary to adjust position of forks for cooking.
□
The rotisserie motor can be assembled on either the left and right side of firebox. If you need to
use the rotisserie and side burner at the same time, you may position the motor over the searing
burner side of the grill. Remove motor, motor support and motor support bracket and reassemble
to the other side of firebox. To detach bracket, remove the two screws and use them to attach the
bracket to the other side.
A
B
C
D