Kenmore 146.48590710, Инструкция по использованию и уходу

Страница: 14 / 84

14 · 146. 485917 10
Notes
For Natural Gas Connection
Preparing:
1. Turn off gas supply, and then remove cap on gas
Supply side.
2. Recommended: Install a shut-off valve on
gas supply side before installing the socket.
3. Socket should be installed by an authorized
technician in accordance with the national fuel gas
code (NFPA 54/ANSI223.1)
4. Before inserting plug, turn on gas supply and leak
test all connections including the stem of the shut-off
valve and the opening of the socket. For best results,
use and ammonia-free soap & water solution.
Operating Instructions:
1. To connect, push back socket sleeve.
2. Insert plug and release sleeve.
3. Push plug until sleeve snaps forward. (Gas will flow
automatically. Failure to connect plug properly to
socket will inhibit gas flow to the appliance.)
Gas Requirements
LP Gas
If your grill is for LP Gas, the regulator supplied is set for
an 11-in. Water column (WC) and is for use with LP gas
only. The factory-supplied regulator and hose must be
used with a 20-Ib. LP gas tank.
Natural Gas
If your grill is for Natural Gas, it is set for a 7-in. water
column (WC) and is for use with Natural Gas only. Gas
pressure is affected by gas line size and the length of
gas line run from house gas line. Follow the
recommendations in the chart below.
To disconnect
1. Pull Sleeve back. Pull plug out socket. (Gas is
automatically shut off.)
2. Close shut-off valve and replace dust caps on socket
and plug.