Kenmore 146.48590710, Инструкция по использованию и уходу

Страница: 41 / 84

Problem
Burner(s) will not light
using igniter.
(See Electronic
Ignition
Troubleshooting also)
Pro
Burner(s) will not
match light.
Sudden drop in gas
flow or low fl ame.
Flames blow out.
Flare-up.
Persistent Drip fire.
• See “GAS ISSUES:” on previous
page.
• Match will not reach.
• Improper method of match-lighting.
• High or gusting winds.
• Low on LP gas.
• Excess flow valve tripped.
• Drip buildup.
• Excessive fat in meat.
• Excessive cooking temperature.
• Drip trapped by food buildup around
burner system.
• Burner and/or burner tubes are
blocked.
Prevention/Solution
• See Section I of Electronic Ignition System.
• See Section II of Electronic Ignition System.
• See Section III of Electronic Ignition System.
• Che ck for gas in LP cylinder.
•Turn off knobs, wait 30 seconds and light grill. If fl ames are
still low, turn o ff knobs and LP cylinder valve. Disconnect
regulator. Reconnect regulator and leak-test. Turn on LP
cylinder valve, wait 30 seconds and then light grill.
•Turn off knobs and LP cylinder valve. Disconnect coupling nut
from cylinder. Reconnect and retry.
• Turn knobs to OFF. Turn gas o ff at LP cylinder. Leave lid in
position and l et fire burn out. After grill cools, remove and
clean all parts.
• Turn knobs to OFF . C lean burner and/or burner tubes. See
burner cleaning section of Use and Ca re.
Troubleshooting (continued)
Possible Cause
ELECT RON IC IGNITION:
• No spark, no ignition noise.
• N o spark, some ignition noise.
• S parks, but not at electrode or at full
strength.
• C lean burners and inside of grill/ fi rebox.
• Trim f at from meat before grilling.
• Adjust (lower) temperature accordingly.
• C lean carry-over tube(s) with wire brush.
One burner does
not light from
other burner(s). • Drip buildup or food particles in end(s
of carryover tube(s).
Flashback…
(
fi re in burner tube(s)).
Unable to fill LP
cylinder.
• Out of gas.
• Excess flo w valve tripped.
• Vapor lock at coupling nut/LP
cylinder connection.
• Some dealers have older fi ll nozzles
with worn threads.
• Turn front of grill to face wind or increase flame heigh t.
• Re fi ll LP cylinder.
• Refer to “Sudden drop in gas flow” above .
• Use lo ng-stem matc h (firep lace match).
• See “M atch-Lighting” section of Use and C are.
• The worn nozzles don’t have enough “bite” to engage the
valve. Try a second LP dealer.
Prevention/Solution
146.48591710 • 41