2
the table and that indicated on the
tool
identification
plate
reproduced.
BEFORE STARTING THE TOOL
Ensure that:
The power supply conforms with
the characteristics of the tool;
The power supply cable and plug
are in perfect condition;
The ON/OFF switch works properly
though with the power supply
disconnected;
All the parts of the tool have been
assembled in the proper manner
and that there are no signs of
damage;
The ventilation slots are not
obstructed.
STARTING AND STOPPING
Starting: push the lever of the
switch towards the body of the
tool; if the tool is to be locked in
the ON position, press button at the
same time and keep it pressed
while releasing lever, thus locking
the switch.
Stopping: release the lever of the
switch or, if locked in position. Push
the lever to release the lock button.
TEST RUN
Start the tool and check that there are no unusual vibrations, or no mismatching of the
buffing pad. Otherwise switch-off the tool immediately and eliminate the fault.
ELECTRONIC RPM REGULATION
The rpm can be adjusted by rotating the wheel. The choice of speed depends on the
characteristics of the buffers and the material to be worked.
REPLACING THE BUFFING PAD
Pull the used pad off and apply the new one, pressing it onto the disc pad.
MAINTENANCE
All maintenance operations are carried out with the power supply disconnected.
At the end of each work session, or when required, remove any dust from the body of
the tool using a jet of compressed air, paying particular attention to the motor
ventilations slots. No other maintenance operations must be undertaken by the user.
Maintenance and cleaning of the inner parts, like brushes, ball bearings, gears etc. or
others, must be carried out only by an authorized customer service workshop.
TOOL IDENTIFICATION PLATE
POSITION AND MAENING OF INFORMATION
1-Type of tool.
2-Nominal working voltage in volts(V).
3-Working frequency in hertz(HZ).
4-Absorbed current in Amperes (A). Ensure that the power supply to which the tool is
connected can easily tolerate the indicated current as a minimum.
5-Absorbed power expressed in Watts(W).
6-Tool code or serial number.
7-Technical data of the tool.
8-Maximum rpm