1
The values shown are based on a nominal voltage of 230V/50Hz. In the case of voltages and
frequencies of different power, values may vary. Refer to the label technical specifications to
the nominal values of the tool.
GENERAL WARNINGS
The safety and accident prevention instructions are reported in the “SAFETY
INSTRUCTION” booklet which forms an integral part of these documents. This
OPERATING INSTRUCTIONS MANUAL indicates the additional information required
specifically for use of the tool.
CORRECT USAGE
This tool is designed to be used as a polisher. Read all the warnings, instructions,
indications provided on drawings and specifications supplied with this tool. Failure to
comply with all the instructions provided below may cause electrical shocks, fire and/or
serious injuries.
This tool is not intended to be used for smoothing, metal brushing and cutting
operations. The use of this tool for unintended applications may cause hazards and
injuries to people.
The tool must be used with accessories that have been specifically designed or
recommended by the manufacturer. The fixing of the accessory to the tool does not
guarantee a safe operation.
The rated speed of the accessories must be at least equivalent to the maximum speed
specified on the tool. Using the accessories at speeds above the rated maximum, may
cause them to break or be projected into the air.
The external diameter and thickness of the accessories must match the specifications of
the tool. Accessories with incorrect dimensions cannot be adequately protected or
controlled.
The configuration of accessories must match the tool. The use of accessories that cannot
be perfectly fitted on the tool may result in imbalance, excessive vibrations and in the
impossibility of controlling the tool.
Do not use damaged accessories. Before use, inspect all the accessories. Inspect the
supporting pads and verify there are no cracks, tears or excessive wear. If the tool or
accessory has been dropped, verify that it is not damaged or install a new accessory.
After inspecting or installing an accessory, test the operation of the tool at maximum
speed and without load for one minute, keeping at a safety distance. If the accessories
are damaged, they will break during this test.
SAFETY WARNING APPLICABLE TO POLISHING OPERATIONS
Verify that no loosened part of the polishing tool shroud or the locking ties can rotate
freely. Safely position or cut all the loosened fixing wires. Loosened or revolving fixing
wires may twist around the operator’s fingers or get caught by the work piece being
machined.
STARTING UP
Before starting-up the tool ensure that:
The packaging is complete and does
not show signs of having been
damaged
during
storage
or
transport;
The tool is complete; check that the
number and type of components
comply with that reported in this
instruction booklet;
The power supply and socket outlet
can support the load reported in