©
www.kemper-olpe.de
– 03.2021 / K410054000001-00 – 21 /88
3
Modification of
Factory Setting
Note!
After this, the valve
has again to be fully
opened (left turn to
end position).
Note!
Do not over-tighten
the end position
buffers!
1. Pull off operating cap
(1).
2. Insert screwdriver into
screw slot (2).
3. Now, the temperature,
pre-set at the factory,
can be modified by
maximum half a turn to
the right. 10 notch steps
correspond to 2 K.
Hereby, stepping is
noticeable.
4. Re-fit operating cap.
5. Check the correct posi-
tion of the regulating
piston (end position!)
by turning the operating
cap (1) to the left.
