K°Bloc – Fully welded plate heat exchangers - English Version 2.2 - 01.2016
78
Observe the following note on removing the baffle plate bracket:
•
Bear in mind that the plate pack and the baffle plate bracket are sensitive
to the action of lever forces.
•
Document the installation position and alignment clearly before removing
a baffle plate bracket so you can refit it properly afterwards.
•
The baffle plate bracket should always be removed as a complete
component.
7.4 CLOSING THE K°BLOC
Before you can close the K°Bloc again, the following pre-conditions must be
met:
•
The K°Bloc gasket was replaced, see chapter „7.2 Replacing the
gaskets“ (page 76).
•
Obtain information in advance if the panel must be tightened to the gap
dimension or to a specified torque.
•
If the baffle plate brackets were removed, they must be fitted back in the
correct position.
