Cleaning and Disinfection of Air Hoses
•
Isolate power supply to Control Hub.
•
Remove air supply hose by loosening jubilee clip and gently easing hose off the air outlet adapter.
•
Remove 90 degrees elbow connector by unscrewing ¾” Air nut and loosening the jubilee clip and gently
pulling apart.
•
Remove air return hose by loosening jubilee clips and gently easing hose off the air inlet adapter and
backplate vent.
•
Put aside all hose clips in a safe place.
•
Whilst wearing the correct safety equipment, dip hoses into a disinfectant solution so all the hoses are
submerged.
•
Remove from solution and clean out hoses using a pipe cleaning brush.
•
Dip hoses into disinfectant solution and flush through, continue this until hoses are clean.
•
Once hoses are clean, flush hoses through with fresh water.
•
Shake out any excess water and wipe dry.
•
Replace air supply hose by gently inserting into air outlet adapter and tightening jubilee clip.
•
Replace 90 degrees elbow connector by gently inserting into hose, screwing ¾” Air nut onto shower head hose
pipes and tightening jubilee clip.
•
Repeat steps for air return hose in reverse for air recirculation installations.
•
Reinstate power supply to Control Hub.
•
Run shower for 2-3 minutes to dry any moisture in the hoses.
Warning!
!
During regular cleaning of the shower area, do not direct a water hose at the shower head while the
shower is functioning. Many household and industrial cleaning products contain mild abrasives and
chemical concentrates and should not be used on this product.
Maintenance
16
