Keithley KPCI-3110, Руководство пользователя

Страница: 125 / 158

C-10 Systematic Problem Isolation KPCI-3110 and KPCI-3116 User’s Manual
d. At the bottom of the Add/Remove Programs Properties dialog box, click Add/Remove
and then follow the remainder of the Windows uninstall prompts.
CAUTION During the course of an uninstall procedure, you will typically be
asked if you wish to uninstall certain files that may be shared by
other programs. In such cases, always click
No . Mistakenly
uninstalling files needed by other programs causes serious problems.
Mistakenly keeping files causes no harm, and some uninstalled files
may be overwritten anyway when you subsequently reinstall
DriverLINX.
13. Reinstall DriverLINX, referring to the brief DriverLINX installation instructions on the
Read This First sheet that was shipped with your KPCI-3110 or KPCI-3116 board and is also
provided on the CD-ROM containing this manual. Make sure that DriverLINX installs
smoothly and completely.
14. Reinstall the board(s).
CAUTION Wear a grounded wrist strap to avoid electrostatic damage to the
board. Do not touch board components or conductors when han-
dling the board.
NOTE If you are performing Scheme B independently as an installation check,
then reinstall all boards that you removed in step 9. If you are perform-
ing Scheme B as part of the systematic problem isolation procedure,
then reinstall only the good board that you began using near the end of
Scheme A.
15. Proceed as follows:
a. Shut down and turn off the computer.
b. Install the board(s) in its expansion slot(s), following this brief procedure in Section 3 of
the manual.
c. Turn ON and reboot the computer.
d. Run the procedure for configuring the board to work with DriverLINX, in Section 3 .
e. Return to step 1 and run the installation check again.
16. You arrived at this step from step 2 , after successfully starting the Analog I/O Panel. Select
your next action based on the criteria given in the following alternatives:
•
If you are performing Scheme B independently as an installation check, then
DriverLINX and your KPCI-3110 or KPCI-3116 board are installed correctly. Return to
Section 3 and finish installing your data acquisition system.
• If you performed Scheme B as part of the systematic problem isolation procedure AND
arrived at this point after reconfiguring the board or reinstalling DriverLINX and the
board, then go to “
Problem isolation Scheme G: verification of problem solution .”
•
If you performed Scheme B as part of the systematic problem isolation procedure AND
arrived at this point without performing any remedial efforts, then your problem must lie
elsewhere. Go to “
Problem isolation Scheme C: application software ” and check for
application software issues.