Keithley KPCI-3110, Руководство пользователя

Страница: 122 / 158

KPCI-3110 and KPCI-3116 User’s Manual Systematic Problem Isolation C-7
i. Inspect the DriverLINX Configuration Panel.
• If you see the following on the screen for a KPCI-3110 or KPCI-3116 board, then the
board is recognized as a device under DriverLINX but is
not properly configured:
– Keithley KPCI-3110 or KPCI-3116 is listed under DriverLINX.
– The amplifier icon next to Keithley KPCI-3110 or KPCI-3116 board listing is
colored yellow.
– The specific board part number(s) of the unconfigured Keithley KPCI-3110 or
KPCI-3116 board(s) is listed under Keithley KPCI-3110 or KPCI-3116.
– The lamp icon next to the specific board part number is uncolored.
•
If you see the following on the screen for a KPCI-3110 or KPCI-3116 board, then the
board is recognized as a device under DriverLINX and
is properly configured:
– Your Keithley KPCI-3110 or KPCI-3116 Board is listed under DriverLINX.
– The amplifier icon next to Keithley KPCI-3110 or KPCI-3116 listing is colored
pale gray.
– A device number — for example, Device0 (or Device1, Device2, etc. ) — is listed
under your Keithley KPCI-3110 or KPCI-3116 board, instead of a specific
board part number.
– The lamp icon next to the device number is colored green.
j. Leave the DriverLINX Configuration Panel open for now and continue with step 5 .
5. Based on the results of step 4, do one of the following:
• If your board is properly installed and configured, your inability to run the Analog I/O
Panel may be due to an improperly installed component of DriverLINX. Skip to step 9,
and begin uninstalling, then reinstalling DriverLINX and the board.
•
If one of your KPCI-3110 or KPCI-3116 boards is apparently recognized by DriverLINX
but is listed in the Device Manager under DriverLINX with a large exclamation point,
then try configuring it with the DriverLINX Configuration Panel. Skip to
step 7 .
• If one of your KPCI-3110 or KPCI-3116 boards is listed under ? Other Devices , or is
listed in the Device Manager at multiple places, then the installation is faulty. Skip to step
9 and begin uninstalling, then reinstalling DriverLINX and the board.
•
If your board is not listed at all in the Device Manager, there are apparently issues other
than the combined DriverLINX/board installation. Continue with
step 6 .
6. Select the next step in Scheme B based on the criteria given in the following alternatives:
•
If you are performing Scheme B independently as an installation check, then non-
installation issues must apparently be resolved before you can successfully run your
board. Starting at “
Problem isolation Scheme A: basic system ,” proceed through the
systematic problem isolation procedure.
• If you are performing Scheme B as part of the systematic problem isolation procedure,
then you should have seen your board listed in the device manager at this point in the
procedure. The cause of your problem may be outside the scope of these diagnostics.
Read the instructions in
Section 6 , “ Technical support ” and then contact Keithley for
help in isolating the cause of your problem.