Keithley KPCI-3110, Руководство пользователя

Страница: 123 / 158

C-8 Systematic Problem Isolation KPCI-3110 and KPCI-3116 User’s Manual
7. Try to reconfigure your board using the DriverLINX configuration panel, which you opened
in step 4 and should still be open. Proceed as follows:
a. In the DriverLINX Configuration Panel, select an unconfigured KPCI-3110 or
KPCI-3116 board by clicking on its part number. An unconfigured KPCI-3110 or
KPCI-3116 board may be identified as follows:
•
The specific board part number of the unconfigured Keithley KPCI-3110 or
KPCI-3116 board is listed under
Keithley KPCI-3110 or KPCI-3116 .
• The lamp icon next to the specific board part number is uncolored.
•
The amplifier icon next to Keithley KPCI-3110 or KPCI-3116 is colored yellow.
b. Click the Configure button. The Select Logical Device dialog box appears.
c. Select your next action based on the criteria given in the following alternatives:
• If only one KPCI-3110 or KPCI-3116 board is installed, a default device number of 0
in the text box is correct. Click OK .
•
If other KPCI-3110 or KPCI-3116 boards are installed and configured and have been
assigned device numbers, then type in a device number for the board you are
configuring—the next, unassigned number in the numbering sequence. Then click
OK .
d. The Configure DriverLINX Device dialog box appears, as well as the Device Manager.
e. No changes in the Device dialog box changes are normally required. Click OK .
f. If a Device Change message appears, then click OK .
g. If more than one unconfigured board was found in the DriverLINX Configuration Man-
ager in step 4, configure the additional boards now. Repeat substeps 7a through 7e for
each remaining unconfigured board.
h. Close out all programs and reboot your computer to complete the configuration process.
i. Open and check the Device Manager as you did in step 4. Your KPCI-3110 or
KPCI-3116 board(s) should now be listed under the DriverLINX with no exclamation
mark over it.
j. Open and check the DriverLINX Configuration panel as you did in step 4. If you success-
fully configured your board(s), you should now see the following listed below Keithley
KPCI-3110 or KPCI-3116 . Refer back to step 4.
•
Instead of a specific board part number(s), there should now be a device number(s) —
for example,
Device0 .
• The lamp icon next to the device number(s) should be colored green.
8. Based on the results of step 7 , do one of the following:
• If the board was successfully configured, return to step 1 and retry starting the Analog
I/O Panel.
•
If the board was not successfully configured, continue with step 9 and begin uninstalling,
then reinstalling DriverLINX and the board.
9. Remove all KPCI-3110 or KPCI-3116 boards physically.
NOTE You should remove all KPCI-3110 or KPCI-3116 boards before rein-
stalling the KPCI-3110 and KPCI-3116 version of DriverLINX, because
the installation order is DriverLINX first, board second. If a KPCI-3110
or KPCI-3116 board is present, physically or in the computer list of
devices, driver installation difficulties may occur.