Keithley 7065, Инструкция по эксплуатации

Страница: 24 / 155

PA-392 Rev. C / July 2009 13 of 21
Program Requirements
The following computer software and hardware is necessary to use these example programs:
• IBM PC, AT, or compatible computer.
• IOtech Personal488, CEC PC-488, or National Instruments PC-II or PC-IIA IEEE-488 interface card for the
computer.
• MS-DOS or PC-DOS version 3.3 or later.
• Microsoft QuickBASIC version 4.0 or later.
• IOtech Driver488 bus driver, rev. 2.3 or later (NOTE: Recent versions of Driver488 may not support other
manufacturers' interface cards).
General Program Instructions
1. With all power turned off, connect all instruments to the IEEE-488 bus, and make the necessary signal
connections, as covered in the Model 7065 Instruction Manual.
2. Turn on the computer and all instruments, and allow them to warm up for their prescribed warm-up periods for
rated accuracy.
3. Make sure the instruments are set for the following primary addresses:
Model 2000: 7 (default is 16)
Model 622x: 12
Model 6485: 22 (default is 14)
Model 7001: 8 (default is 7)
All the above addresses are factory default with the exception of the Model 7001 address, which must be
changed to avoid address conflicts (see the instructions in paragraph 8 for details on changing the Model 7001
address).
4. Make sure the IEEE-488 bus driver software is properly initialized.
5. Enter the QuickBASIC editor by typing in the following while in the QuickBASIC directory:
QB <Enter>
6. Type in the desired program, then check it for errors. Save the program under a convenient filename.
7. Run the program by pressing <Shift> + <F5>. Follow the prompts on the screen to run the test.