Keithley 7037, Инструкция по эксплуатации

Страница: 27 / 72

Card Connections and Installation
4-8
Typical connection techniques
All external circuitry, such as instrumentation and DUTs,
that you want to connect to the card must be terminated with
a single 96-pin female DIN connector. The following con-
nection techniques provide some guidelines and suggestions
for wiring your circuitry.
WARNING
Before beginning any wiring proce-
dures, make sure all power is off and
any stored energy in external circuitry is
discharged.
WARNING
When wiring a connector, do not leave
any exposed wires. No conductive part
of the circuit shall be exposed. Properly
cover the conductive parts, or death by
electric shock may occur.
NOTE
It is recommended that external circuitry
be connected (plugged in) after the Model
7037 is installed in the Model 7001/7002
mainframe and with the mainframe power
off. Installation is covered at the end of
this section.
Round cable assemblies
 Figure 4-8 shows typical round
cable connection techniques using accessories available
from Keithley.
Figure 4-8
Typical round cable connection techniques
Multi-Pin
Connector
Card
7011-MTC-2
cable assembly
7011-MTR
bulkhead connector
A)
Wire instrumentation
and DUT to bulkhead
connector (See Table 4-2
and Figures 4-7 and 4-9
for terminal identification)
Multi-Pin
Connector
Card
B)
7011-MTC-2
(Cut in Half)
Wire directly to
instrumentation
and DUT
Multi-Pin
Connector
Card
C)
Cable
Wire directly to
instrumentation
and DUT
7011-Kit-R
Connector Kit
Notes: Figure 4-10 provides an exploded view showing
how the connector (with cable) is assembled.
Cable Hitachi p/n N2807-P/D-50TAB is a
50-conductor cable. Two of these cables
can be used to supply 100 conductors.