Keithley 7037, Инструкция по эксплуатации

Страница: 20 / 72

4
Card Connections and
Installation
4-1
Introduction
WARNING
The procedures in this section are
intended only for qualified service per-
sonnel. Do not perform these proce-
dures unless qualified to do so. Failure
to recognize and observe normal safety
precautions could result in personal
injury or death.
The information in this section is arranged as follows:
• Handling precaution —
Explains precautions that
must be followed to prevent contamination to the card.
Contamination could degrade the performance of the
card.
•
Digital I/O connections —
Explains the voltage source
jumpers, pull-up resistors, output logic, and input resis-
tance and how to configure them.
• Multi-pin (mass termination) connector card —
Cov-
ers the basic connections to the 96-pin DIN male con-
nector and identifies each terminal.
• Typical relay switch connection scheme —
Provides
a typical connection scheme for a relay switch
configuration
• Typical digital I/O connection schemes —
Provides
some typical connection schemes for output solenoid,
relay, motor, and logic device control and for input
micro-switch monitoring.
• Model 7037 installation and removal —
Provides the
procedures to install and remove the card from the
Model 7001/7002 mainframe.