Keithley 7035, Инструкция по эксплуатации

Страница: 30 / 74

4
Operation
4-1
Introduction
The information in this section is formatted as follows:
• Power limits — Summarizes the maximum power lim-
its of the Model 7035 card.
• Mainframe control of card — Summarizes the pro-
gramming steps to control the card from the
Model 7001/7002 mainframe.
• Multiplexer switching examples — Provides some
typical applications for using the Model 7035.
• Measurement considerations — Reviews a number of
considerations when using the Model 7035 to make
measurements.
Power limits
CAUTION
To prevent damage to the card, do not
exceed the maximum signal level speci-
fications of the card.
Maximum signal levels
To prevent overheating or damage to the relays, never exceed
the following maximum signal levels:
60V DC, 30V rms, 42V peak between any two inputs or
chassis, 1A switched, 30VA (resistive load).
Mainframe control of card
The following information pertains to the Model 7035. It
assumes that you are familiar with the operation of the
Model 7001 or Model 7002 mainframe—whichever is used.
If you are not familiar with the operation of the mainframe in
use, proceed to Getting Started (Section 3) of the
Model 7001 or Model 7002 Instruction Manual after reading
the following information.