Keithley 7035, Инструкция по эксплуатации

Страница: 26 / 74

Card Connections and Installation
3-5
Figure 3-3
Model 7011-MTR connector pinout
In Figure 3-2B, connections are accomplished using a
Model 7011-MTC-2 cable assembly that is cut in half. The
96-pin female DIN connector on one end of the cable mates
directly to the multi-pin connector card. The unterminated
end of the cable is wired directly to the instrumentation and
DUT. The other half of the cable assembly could be used for
a second card.
In Figure 3-2C, connections are accomplished using
a custom-built cable assembly that consists of a
Model 7011-KIT-R connector and a suitable round cable.
Hitachi cable part number N2807-P/D-50TAB is a 50-con-
ductor cable. Two of these cables can be used to supply 100
conductors. The connector has solder cups to accommodate
the individual wires of the unterminated cable. Figure 3-4 pro-
vides an exploded view of the connector assembly and shows
how the cable is connected. For further Model 7011-KIT-R
assembly information, refer to the packing list provided with
the kit. The connector end of the resultant cable assembly
mates directly to the multi-pin connector card. The untermi-
nated end of the cable assembly is wired directly to the instru-
mentation and DUT.
Figure 3-4
Model 7011-KIT-R (cable) assembly
View from solder
cup side of
connector
32 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1
a
b
c
Note : See Figure 3-1 and Table 3-1 for terminal identification.