(2). Water Cycle Timer Setting
1.
After finishing Light Timer Setting, press the “SET” button to enter Water Cycle Timer setting.
“Water Cycle 2” icon and the first two digital display flash, press “+” or ”-“ to edit the interval time
(1-8 hours).
b. After editing the interval time, press the “SET” button to enter the sprinkling time setting. “Water
Cycle 2” icon and the last two digital display flashes, press “+” or ”-“ to edit the interval time (1-30
minutes). (Figure 28)
Note: For instance, the display in Figure 28 shows 04:02 (For every 4 hours, Water cycle is 2 minutes)
(3). Delay Light-Up Timer Setting
(
6) Press the “SET” button, “Plant Light 2” icon and the first two digital display flash, press “+” or ”-“ to
adjust time (1-99 hours). Setting can be exited automatically either by pressing “OK” button or hand off
for 10 seconds.
Note: This Timer setting is for the 1
st
Light-Up time of Seedling layer. For instance, with the setting of 72
hours, it means that the light will turn on at the seedling layer after the 72 hours of starting the Seedling
Mode.
4). Sprouts Mode (Custom)
（
1
）
Water Cycle Interval Timer Setting
(1) Hold the “SET” for 3 seconds and you should hear a “Beep” sound. Vegetable icon flashes, press the
“SET” for seedling icon flashes, press the “SET” again for both Sprouts and “Water Cycle 2” icon flash,
and enter Sprouts Mode (Custom).
(2) “Water cycle 2” icon and the first two digital display flash, press “+” or ”-“ to edit interval time (1-8
hours)
(3) After editing the interval time, press the “SET” to enter the Water Cycle time range setting. “Water
Cycle 2” icon and the last two digital display flash, press “+” or ”-“ to edit the sprinkling time range (1-30
minutes). Setting can be exited automatically either by pressing “OK” button or hand off for 10 seconds.
Note: For instance, the display in Figure 30 shows 04:02 (For every 4 hours, Water cycle is 2 minutes)