(1)
Switch on the water pump switch.
(2)
Choose Sprouts Mode in the screen.
(3)
In general, sprouts can be collected after one week.
(4)
First, take out the sprinkling tray and unplug the pump.
(5)
Next, take out the tray with the tray cover. Lastly, cut off the sprouts.
(6)
Repeat the above steps to grow other sprouts.
Notes
:
(a)
Before the next planting, clean tray and water pipe cover.
(b)
In general, growth process of sprouts are 7 days.
(c)
To assure the quality of the sprouts, please do not open the shade hood during the growth
process.
4.2.3 Seedling Cultivation Mode
4.2.3.1 KES1.0 Seedling Mode
(1) Similar to Sprouts Mode, please refer to Step 1-5 of Sprouts mode.
Note: In general, 100~150ml of warm water is required for soaking bean for 6 hours. Remove the
unsoaked and defective seeds.
(2) After finishing the above steps, turn on the pump and plant light, take off the gauze.
(3) Choose Seedling Mode from the screen.
(4) Take off the shade hood and blackout cover on the sprinkling tray
(5) After 3 days the plant light will automatically turn on. Then cover the sprinkling tray again. At the
same time, to avoid water leakage outside the product, please pay attention to the water tubes.
Note: During the growth process, take off the shade hood.
(5) Adding Nutrient Solution
After the lights turn on for a day (that is 4th day of planting), Nutrient Solution can be added. (Sprouts
does not need to add Nutrient Solution)
Volume required: Nutrient Solution A: 60ml, 2caps
Nutrient Solution B: 30ml, 1 cap
(6) Seedlings can be collected around 10 days (seed can be collected by depending on their growth
process). Cut at 0.8-1cm of the bean valve, seedling can grow again.
Note: If you found the recycling water is too much during planting, please adjust the water level.
(7) After collecting the second time growth seedlings, clean the trays and seedling trays. Make sure the
pumps are unplugged before taking out the trays.
(8) Repeat the above steps to grow seedlings.
4.2.3.2 KES2.0 Seedling Mode
(1) Similar to Sprouts Mode, please refer to Step 1-5 of Sprouts Mode.
Note: In general, 100~150ml of warm water is required for soaking bean for 6 hours. Remove the
unsoaked and defective seeds.
(2) After finishing the above steps, open the pump and plant light, take off the gauze.
(3) Choose Seedling Mode from the screen.