Keiser Keiser 300, Руководство по запасным частям и обслуживанию

Страница: 38 / 46

38
LAT PULL DOWN
CYLINDER ADJUSTMENT
NOTICE: CYLINDERS ARE FACTORY-ADJUSTED AND REQUIRE NO
FURTHER ADJUSTMENT UNLESS THEY ARE REPLACED. Please contact
KEISER if you have any questions concerning adjustments or repairs.
The Lat Pull Down cylinder is properly adjusted when 10 threads are visible on the
cylinder rod above the jam nut (pg. 13 maintenance manual).
CABLE INSPECTION
The cable and snap must be checked WEEKLY. Decrease the resistance to zero and
remove the handle. Check the snap and the hole in the handle for wear. Visually inspect
the cable, paying close attention to those areas that pass over pulleys. Small cracks that
go around the outside of the plastic cover indicate wear and the cable should be replaced
when these appear. Discoloration of the cable does not affect its performance.
The bearings in the pulleys should also be checked at this time. Pulleys that are rough or
noisy should be replaced.
SPRING PINS
1. When installing the spring pin 3/16 X 7/8 (item # 94) into the lever arm (item # 82),
line up the hole in the lever arm with the hole in the lever arm pivot shaft (item # 47).
Drive the spring pin in until the end is 1/16” into the lever arm.