KegLand KL25164, Руководство по установке

Страница: 6 / 12

KL25164 – Chuck Installation Manual
Page
6
of
12 www.KegLand.com.au Last Updated 21/12/2022 16:17 PM
After you install the chuck and reinstall the 1st Op Roller onto the Single Lane Cannular you will then
need to adjust the 1st Operation and 2nd Operation Roller Positions relative to the chuck to bring
the machine into specification.
To do this follow the instructions below:
2.0 Adjust 1 st Op and 2 nd Op Roller Height (y-Gap)
Undo the lock nut on the thread above the 1
st
Operation Roller.
Then adjust the height of the roller by rotating the thread clockwise or counter clockwise to the
desired height of the roller relative to the chuck. Then set the height by tightening the lock nut
firmly.
After adjusting the roller height and before operating the Cannular it is vital that you check that
the roller does not make contact with the chuck.
To confirm this, disconnect the air supply to the
unit. Then manually push the roller towards the chuck (so that the piston is fully actuated) then spin
the roller with your hands to make sure it does not hit the chuck.