MAINTENANCE MANUAL
Mirage technical manual
page 18 of 65
Procedure upper side panels
Remove appropriate side panel first.
Warning!
It is essential to disconnect the Mirage from the power outlet before removing the upper side panels,
especially the one on the left hand side.
1. Unscrew the 2.5 mm Allen bolts on the upper finishing strip a few turns.
Figure M 6. Remove finishing strip first, then undo 2 Allen bolts at back of upper-side panel. Slide
panel forward to unhook from front panel.
2. Pull the finishing strip sideways from machine, try not to scratch the body panels.
3. Remove the two 3 mm Allen bolts from the back of the upper side panel.
4. Slide panel forward (towards barista side) to unhook from front panel.
Remounting upper side panel
1. Place upper side panel close to frame and make sure that it hooks onto front panel.
2. Mount the 3 mm Allen bolts. Make sure the barista side of the upper side panel is pushed
backwards a little and flush with the side of the front panel.
3. When remounting the finishing strip it may be useful to remove the two 2.5 mm Allen bolts on the
rear completely before remounting the strip.
4. Remount these two Allen bolts but do not tighten any of the 2.5 mm Allen bolts yet.
5. Take the glass or aluminium side panel and mount with (glass) nuts and rubber rings until it
touches both the front and rear body panels.
6. While tightening the bolts on the finishing strip, pull the Allen bolts and thus finishing strip towards
the side panel.
upper finishing
strip
2 Allen bolts