USER MANUAL - operation
Slim Jim User manual
page 5
Bastone unit
A bastone unit includes a brew lever, an
indicator light, a momentary push button and a
two-position toggle switch.
Shortly pressing the brew lever will start the pre-
set volume determined by the toggle-switch. A
pre-set volume can be stopped before the
volume is reached by shortly pressing the brew
lever again.
When the group is active, the indicator LED is lit.
The push button is the continuous (“on/off”)
switch with programming function.
The toggle switch determines which of the two
possible pre-set volumes is active.
Figure 4. Bastone unit.
The push button underneath each brew lever is the continuous (“on/off”) switch equivalent to button #5
on a touchpad (see below). The indicator light will light up continuously when the controller is in
programming mode. A continuous dispense can also be stopped by shortly pressing the brew lever.
Touchpad
A touchpad has 5 momentary push buttons with
internal indicator LED.
The upper button (#5, larger circle) is an on/off
group switch with programming function.
Buttons #1-4 are used to start a pre-set volume.
A pre-set volume can be stopped before the
volume is reached by shortly pressing any
button.
When the group is active, the indicator LED of
corresponding button is lit.
Figure 5. Touchpad.
Press the upper button briefly to open the group valve and activate the pump, the LED in the button
will light up. Press it briefly again to deactivate the pump and group valve, the LED will go off.
Press the upper button and keep pressed to get the controller in programming mode such that shot-
volumes (and hot water timer) can be programmed. The indicator LED of the upper button will flash
and the other 4 will be lit continuously. Press and keep pressed again to leave programming mode.
For shot-volume programming with bastone units or touchpads see page 14: Program volumes with
touchpad or bastone.
start/stop
volumes
volume 2
←
→
volume 1
replace
with new
photo
920 x
(max)
780
on/off group
(program)
indicator LED
