ECLIPSE – INSTALLATION/OPERATION MANUAL
Eclipse
Jan-10
4
1.7 RESTARTING
FURNACE
Follow this procedure before restarting a unit that has been shut down for an extended period
of time.
INSPECTION
Have the furnace/system serviced and inspected by a qualified technician.
FUEL
Turn on fuel supply and check that there are no leaks.
POWER
Turn on power switch and check that the furnace starts and operates as
usual.
OPERATION
If the furnace/system fails to operate or operates in an unusual manner, call
your service technician. If the burner fails to operate at any time, call a
qualified burner technician.
2.0 INSTALLATION
2.1 IMPORTANT
This manual contains instructional and operational information for the Eclipse
Classic Air
,
EVO
and
MAX
units. Read the instructions thoroughly before installing furnace or starting
burner. Consult local authorities about your local Fire Safety Regulations. All installations
must be in accordance with local state or provincial codes. Improper installation will result in
voiding of warranty.
Ensure
that the two piece ceramic target wall is correctly placed at the
back of the heat exchanger if using a Beckett burner.
2.2 CAUTION
DO
NOT
START THE BURNER UNTIL ALL FITTINGS, COVERS AND DOORS ARE IN
PLACE.
DO
NOT
TAMPER WITH THE FURNACE OR CONTROLS, CALL A QUALIFIED
BURNER TECHNICIAN.
DO
NOT
STORE OR USE GASOLINE OR OTHER FLAMMABLE
VAPOURS AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
2.3 INSTALLATION
CODES
INSTALLATION MUST COMPLY WITH THE REQUIREMENTS OF AUTHORITIES HAVING
JURISDICTION. All local and national codes governing the installation of oil burning
equipment, wiring, and venting must be followed. Some of the applicable codes are:
CAN/CSA B139
Installation Code for Oil Burning Equipment.
NFPA 31
Installation Code for Oil Burning Equipment.
ANSI/NFPA 90B
Warm Air Heating and Air Conditioning Systems.
ANSI/NFPA 70
National Electrical Code.
CSA C22.1
Canadian Electrical Code.
ANSI/NFPA 211
Chimneys, Fireplaces, Vents and Solid Fuel Burning Appliances.
Certified to CSA and UL requirements. Use only nozzles and settings shown on the operating
decal. Use approved fittings, tubing, fuel tank, oil shut off valves etc. The latest versions of
the above codes, which have been approved for use in the location of the installation, must be
used.
