Long-Range Medium-Load PTZ Camera
User Manual
68
Set duration: configure arming durations according to actual requirements.
Click the blue bar to pop up a window for editing the accurate start time and end time;
click "
Save
" to validate setting.
Click any duration and there will be small white squares on the 2 ends of it. Put the
mouse on any whit square, left-click and drag the edit the start time and end time.
Select the timeline of any day and delete the default blue bar. Left click on the mouse
and drag on the timeline from left to right to form a blue bar, above which it shows the
start time and end time.
Copy duration: click the copy icon
behind the timeline and copy the durations on the
day to one or several other days.
Delete duration: click "
Delete All
" above the timeline to delete all the durations. Select any
duration and click "
Delete
" on the popup window or above the timeline to delete the
duration.
Note: Select any duration with a mouse, and drag the blue bar on the timeline as a whole
without changing the length of recording duration.
8) Click "
Save
" to validate settings.
6.1.2
Video Blocked
When the preset area is blocked intentionally and affects normal surveillance of this area, an alarm
will be triggered. After receiving the alarm, user can find the cause of video blocked quickly and
recover the surveillance scene. Configuration steps are as follows:
1) Go to
Settings > Event > Intelligent Function > Video Blocked;
2)
Select “
Enable
”;
3) Adjust the surveillance scene through the PTZ;
4) Set video blocked area, the default being full area
detection. Click “
Clear All
” and then “
Edit
”
and the image will be divided into 16 columns and 12 lines of small squares. Click a square,
drag toward lower right and click “
Stop
”. Then the area is the detected area and it turns purple
red. A camera can support max 1 video blocked area at the same time;
5) Drag the slide bar to adjust
Sensitivity
; the higher the sensitivity is, the easier it will trigger an
alarm;