KED Spiri II Trend, Руководство пользователя

Страница: 10 / 16

10
b)
Close the clip (see figure 3). Open and slide the belt tensioner (see fig. 5) so that
the front and back straps run together behind your ear, and then center the clip-in
lock beneath your chin. If the straps are not tight and close-fitting, you need to
tighten the excess length of the strap on the clip-in lock. Open the locking plate on
the male part and set the strap length. Repeat this step until the belt system is tight
and close-fitting. Close the locking plate on the clip-in lock again and close tight
on the belt tensioners. The clip-in lock should not be directly against your chin.
c)
The chin strap should be close-fitting but not restrict breathing or swallowing.
d)
Lock the strap in position by turning the Quickstopp, if available,(fig. 4a) to „On“
until it clicks in or (fig. 4b) close the lever untill it clicks.
7. Extras
7.1 Lighting
If your KED bicycle helmet is equipped with an adjustment system with flashing
lights, then follow the instructions below: You can switch the lights on and off by
pressing (see figure 6).
Battery change: use a narrow flat screwdriver to open the housing (see figure 7),
remove the board and replace the batteries.
8. Care, cleaning and storage
The comfortable padding can be cleaned with a moist cloth. A mild soapy solution
or diluted, delicate washing powder can be used as a detergent.
The padding and straps should be dried at room temperature.
The shell of the helmet should be cleaned with lukewarm water and a mild soapy
solution. Do not use any solvents such as thinners or similar products.
Excessively high temperatures or strong UV rays can damage your helmet. It
should therefore not be stored in temperatures above 60° C, such as on the back
shelf of a car. Do not place it on or near to a source of heat such as an oven. The
helmet should simply be kept in a dry place.
The helmet should be checked for visible defects at regular intervals. Minor scrat-
ches do not affect your helmet‘s level of protection.
Only original parts should be used for repairs.
Please consult your dealer.