KeContact R10 CM
2
Installation Manual V 1.01
(translated)
2. Introduction
2.1
Purpose of the document
This document describes start up and operation of the KeContact R10.The figures and
explanations contained in this manual refer to a typical device design. The design of the
device may deviate from it.
2.2
Preconditions
This document contains information for persons who, due to their special training, exper
-
tise and experience as well as knowledge of current standards, are able to assess the work
performed and the possible hazards.
2.3
Intended use
The device is a “cable management” for the indoor and outdoor area (see warning 3.2) at
which electrically operated vehicles can be charged (e.g. electric automobiles).
The KeContact R10 is designed for installation on a wall or ceiling.
The respective national regulations must be observed with regard to the installation and
connection of the KeContact R10.
The intended use of the device always includes the compliance with the environmental
conditions for which this device was developed.
The device was developed, manufactured, inspected and documented in compliance
with the relevant safety standards. Therefore, the products do not pose any danger to
the health of persons or a risk of damage to other property or equipment under normal
circumstances, provided that the instructions and safety precautions relating to the
intended use are properly observed.
2.3.1
Contents of this document
•
Safety notes
•
Installation
•
Operation and handling
•
Maintenance
2.3.2
Not contained in this document
•
Charging station installation manual usually called Wallbox.
Introduction
