P30
Authorization
Operating instructions V3.22
19
© KEBA
5.2.2
Teaching in the RFID master card
The RFID master card is the card that is taught in as the first card at the
charging station. It is required for teaching in additional RFID slave cards. In
addition, it can also be used to authorize a charging procedure.
No charging session may be active for the teaching in and no vehicle may
be connected to the charging station.
Information
If RFID cards have previously been taught in, they will be deleted in the
course of the teaching-in procedure!
To teach in the RFID master card, proceed as follows:
1) Remove the housing cover and connection panel cover to access the
service button (see
5.2.1 Preparing the charging station
).
2) Hold the service button
1
pressed in the connection panel until the sec-
ond signal tone sounds (approx. 10 seconds).
The charging station now performs a restart automatically.
3) Immediately after rebooting the charging station, an RFID master card
must be taught in within 60 seconds by holding it in front of the RFID
reader.
A successful teaching-in process is confirmed by a signal tone.
Information
After teaching in the RFID master card, the LED bar flashes green for a fur-
ther 60 seconds and a charging session authorized by the RFID master
card can be started. After this, the LED bar flashes blue to indicate that au-
thorization to start a charge is required.
