KEB COMBIVERT P6, Инструкция по эксплуатации

Страница: 12 / 48

2. Safety Instructions
2.1 General instructions
Danger Electric Shock
KEB COMBIVERT units contain dangerous voltages which can cause death
or serious injury.
Care should be taken to ensure correct and safe operation to minimise risk
to personnel and equipment.
Attention Only Qualified Electro-Personnel
All work to installation and start-up as well as maintenance may only be done by qualified
personnel (IEC 364 and/or CENELEC HD 384 and IEC-Report 664 and note national safety
regulations). According to this manual qualified staff means those who are able to recognise
and judge the possible dangers based on their technical training and experience and those
with knowledge of the relevant standards and who are familiar with the field of power trans -
mission.
Attention Observe Standards
The inverter or servo drive must not be started until it is determined that the installation com-
plies with the Machine directive (note EN 60204) as well as the EMC-directive.
The COMBIVERT meets the requirements of the Low-Voltage Directive. The harmonized
standard of the series EN 61800-5-1 (VDE 0160) is used.
This is a product of limited availability in accordance with IEC 61800-3. This product may
cause radio interference in residential areas. In this case the operator may need to take cor-
responding measures.
2.2 Transport, storage and installation
The storage of the COMBIVERT must be done in the original packing. It is to be protected
against humidity and excessive cooling and thermal effect. A long-distance transport must be
carried out in the original packing. It is to be secured against impact influence. Observe the
marking on the final packing! After removing the final packing the COMBIVERT must be set
down on a stable base.
12
Safety Instructions