KEB COMBIVERT P6, Инструкция по эксплуатации

Страница: 18 / 48

18
Technical Data
3.1 Overload function
(from inverter firmware 2.2.0.43)
The permissible overload time is considerably depending on the cooling conditions. The over-
load protection of the inverter is triggered by the following reasons:
•
permissible heat sink temperature is exceeded => OH („Error! Overtemperature“)
• exceeding the disconnecting time in accordance with the characteristic above => OL („Er-
ror! Overload“)
3.1.1 AC motor (18/19P6)
Overload function (OL)
Disconnecting time [min]
0
5
10
15
20
100 110 120 130 140 150 160 170 180 190 200 210 220 230
Load [%]
Figure 1: Maximum disconnecting time depending on the load at AC motors
Overload function in the lower speed range (OL2)
in the lower speed range the permissible output current is depending on the output frequency.
Depending on the setting of parameter is14 the error E.OL2 is triggerd or the output current
is limited on exceeding the output current.
Output current [A]
0 A
20 A
40 A
60 A
80 A
100 A
120 A
0 10 20
19P6, 2 kHz
18P6, 4 kHz
Output frequency [Hz]
Figure 2: Output current depending of theoutput frequency