KEB COMBIVERT F5 Series, Инструкция по эксплуатации

Страница: 31 / 116

GB - 13
GB
The technical data is for 2/4-pole standard motors. With other pole numbers the inverter must be
dimensioned onto the motor rated current. Contact KEB for special or medium frequency motors.
Site altitude max. 2000m. With site altitudes over 1000m a power reduction of 1% per 100m must
be taken into consideration.
Technical Data
An input choke is necessary from size 23!
20 21 22 23 24
R R R R U R U
3 3 3 3 3
[kVA] 52 62 80 104 125
[kW] 37 45 55 75 90
[A] 75 90 115 150 180
[A] 112 135 172 225 270
[A] 135 162 207 270 324
[A] 83 100 127 165 198
[A] 100 160 160 200 315
[kHz] 8 4 8 4 8 2 8 2 4 8
[kHz] 16 16 16 12 8 8
[W] 900 1000 1100 1200 1500 1300 1900 1700 2000 2400
[A] 75 90 115 115
127,5
150 144 180
[A] 75 63 90 80 115 90 150 108 180
[A] 34 45 54 46 51 - - - -
[°C] 90
[mm²] 35 50 50 95 95
[Ohm] 9 8 6 5 4
[Ohm] 12 10 8,6 6,7 5
[A] 88 100 133 160 200
1
[Nm] 6 15
[V] 305...500 ±0 (400 V Nominal voltage)
[Hz] 50 / 60 +/- 2
[V] 3 x 0...U Mains
[Hz] see Control board
[m] 50
[°C] -25...70 °C
[°C] -10...45 °C -10...40 °C
IP20
max. 95% without condensation
EN 61800-3
-
3K3 in accordance with EN 50178
Mains voltage
5)
Mains frequency
Output voltage
Output frequency
Max. shielded motor line length
Storage temperature
Operating temperature
Model / protective system
Relative humidity
EMC tested according to
Vibration/Jolt according to
Climatic category
Inverter Size
Housing size
Phases
Output nominal power
Max. rated motor power
Output nominal current
Max. short time current
1)
OC-tripping current
Nominal input current
Max. permissible mains fuse (inert)
Rated switching frequency
Max. switching frequency
Power loss at nominal operating
Stall current at 4kHz
2)
Stall current at 8kHz
2)
Stall current at 16kHz
2)
Max. heat sink temperature TOH
Motor line cross section
3)
Min. braking resistor
4)
Typ. braking resistor
4)
Max. braking current
Overload curve (page appendex)
Tightening torque for terminals